nerc.ac.uk

Reliability Case Notes No. 4: Autosub6000 and Autosub3 actuator potentiometer failure analysis and testing report

Furlong, M.E.; Brito, M.P.. 2009 Reliability Case Notes No. 4: Autosub6000 and Autosub3 actuator potentiometer failure analysis and testing report. Southampton, UK, National Oceanography Centre Southampton, 30pp. (National Oceanography Centre Southampton Research and Consultancy Report 58)

Before downloading, please read NORA policies.
[img]
Preview
PDF
NOCS_R&C_58.pdf

Download (3MB) | Preview

Abstract/Summary

During the James Cook Cruise 27 Autosub6000 aborted mission 12 due to a failure in the position feedback potentiometer of the stern plane actuator. The same actuator is used on Autosub3 which is heading to the Pine Island glacier in Antarctica in January 2009. A similar failure of the Autosub3 actuator while under the ice would result in the loss of the AUV. This report initially describes the investigation into the failure of the feedback potentiometer and shows that the potentiometer’s conductive plastic track became detached from its ceramic substrate and broke up. The report then describes the testing performed to evaluate the reliability of the potentiometer. This involved an accelerated aging test to simulate the worst case conditions seen by the potentiometer in the actuator. This was achieved by oscillating the potentiometer at 4Hz to simulate the actuator movements whilst cycling the pressure of the Morlina 10 oil surrounding the potentiometers. During the testing the 10kΩ potentiometers used in the actuator were not available, and so 5kΩ potentiometers from the same range were tested as a substitute. It was assumed that these 5kΩ potentiometers would produce similar results, however it was found during the testing that the formulation of the 5kΩ potentiometer track was different from the 10kΩ; whether this affects the reliability is not known. Due to the large amount of time required to perform each test only 16 5kΩ potentiometers were tested. Although no failures occurred, the sample was too small to give a high statistical confidence that the potentiometers would survive the cruise. To further reduce the risk four 5kΩ potentiometers that were to be used on Autosub3 were tested for approximately 72 hours in a ‘burnt in’ process. As an early failure similar to that of Autosub6000 potentiometer would have been detected during this process, the chance of the potentiometers failing was significantly reduced. Thus the burnt in potentiometers were considered acceptable for use on Autosub 3 during the Pine Island campaign.

Item Type: Publication - Report (Technical Report)
Additional Keywords: Autosub, Autosub6000, Autosub3, potentiometer, actuator, failure
Date made live: 02 Jun 2009 +0 (UTC)
URI: http://nora.nerc.ac.uk/id/eprint/166320

Actions (login required)

View Item View Item

Document Downloads

Downloads for past 30 days

Downloads per month over past year

More statistics for this item...